CubeSat Project 1 Instructions

Download the final code here.

1. Clear the display, and print “Hello”. Run your program to test it.

3. Set the name variable, and change your print to print “Hello” and then your name variable.

5. Use the “on start” block to set a new “timestep” variable to 0. Do not call this variable “time”.

7. Add a “when button A was pressed” block with “exit program” inside it, to let you quit your program. Run it to test that it counts up every second and you can quit it.

2. Create a new variable called “name”.

4. Test your program. Once it is working, you can click “New” and we’ll start the project.

6. Add an “every 1 seconds” block, and inside it, “change” the timestep, then clear the display and print “time” and your “timestep” variable.

8. Create a new “accel” variable, and use the accelerometer sensor to set it to the magnitude.

9. Also print the acceleration value to the display.

This is the final program. Run it to make sure that it prints both values to the screen, and stops when you press A.